Note: firstly please cut off the power supply and discharge refrigerant out of the unit.
Remove the fixing bolts and electric box.
Remove fixing bolts, desolder connection points between
gas/liquid lines of the plate-type heat exchanger and the
main unit, and then remove the water system.
Note:when desoldering the connection joint, pay attention to
covering the solder joints with a wet cloth to avoid high
temperature damage.
Desolder connection points of the 4-way valve, and remove
the pipelines of the 4-way valve.
Note:when desoldering the connection joint, pay attention to
covering the solder joints with a wet cloth to avoid high
temperature damage.
Desolder connection points of the suction lines and remove
suction lines.
Note:when desoldering the connection joint, pay attention to
covering the solder joints with a wet cloth to avoid high
temperature damage.
To Next Page
Loading...