56
Note: firstly please cut off the power supply and discharge refrigerant out of the unit.
Desolder connection points of the economizer, remove fixing
bolts and then remove the economize.
Note:when desoldering the connection joint, pay attention to
covering the solder joints with a wet cloth to avoid high
temperature damage.
Remove fixing bolts of the compressor and the gas-liquid
separator, and then remove the compressor and the
gasliquid separator.
Remove fixing bolts and then then fan.
Remove fixing bolts of the motor and the motor support and
then move them.
Remove fixing bolts, and then separate the condenser from
the base.
To Next Page
Loading...