Argo AG4HP061PH - Electric Box and Heat Exchanger Removal; 4-Way Valve Removal

Air-to-water Heat Pump
58
Note: firstly please cut off the power supply and discharge refrigerant out of the unit.
Operation Procedure
Illustration
AG4HP081PH; AG4HP101PH; AG4HP121PH; AG4HP141PH; AG4HP161PH; AG4HP103PH; AG4HP123PH;
AG4HP143PH; AG4HP163PH
Remove the cover of both the electic box and the
inductance box.
Fig. 5
Remove the electric box and the inductance box.
Fig. 6
Remove fastening bolts, desolder the joints between the
plate heat exchanger gas/liquid pipe and the refrigerant
system, and then remove the water system. (when
desoldering the connection joint, pay attention to covering
the solder joints with a damp cloth to avoid high
temperature damage).
Fig. 7
Remove the 4-way valve.
• Loosen the screws fixing the coil of 4-way valve
• Remove the coil of 4-way valve
• Unsolder the tubes connected to the 4-way valve.
• Remove the 4-way valve.
• Note:when desoldering the connection joint, pay attention
to covering the solder joints with a damp cloth to avoid
high temperature damage.
Fig. 8