22
KRYPTON PRO 302A 8. Stem Assembly
Stem Assembly - Step #1
After completion of the frame’s internal cable
routing (refer to section 6. or 7.), you will have
two cable / hose coming out of the HT:
• Rear brake hydraulic housing (BR)
• Di2 cable (EW)
Note: Make sure the cable and hose are not pulled
too much inside the frame. Leave some spare
length by slightly pushing back a few cm length
of cable / hose. This can help later to better adjust
the t when changing the stack height or reach
length without having to rebleed the system.
BR
BR = Brake Hose
EW = Electronic Wire
EW
To Next Page
Loading...
