Argox OS-214 plus - Troubleshooting; LED Diagnosis

47
Troubleshooting
Normally, when the printer is in not working properly, the "Power"
LED blinks continuously; while printing and communication
between the host and printer stops.
LED Diagnosis
Power and Ready LEDs blinking continuously indicates printer
errors. To understand the problem, please observe the Power and
Ready LEDs and refer to the following solutions:
LED Indicators: Power and Ready LEDs blink at the same tempo
Power LED
Ready LED
ON
ON
OFF
OFF
Possible Problems
Solutions
Remarks
Miss-detect gap
Check the label path
Check the label sensor
If you use a
continuous label roll
and run under
Windows, select
continuous media.
Label stock out
Supply the label roll
Label stock not
installed
Install the label roll