Argox X-2300 - Troubleshooting; LED and LCD Diagnosis; Media Problems

71
4. Troubleshooting
Normally, if the printer is in not working properly, the "READY" LED
blinks continuously, and printing and communication between the
host and printer stops.
LED and LCD Diagnosis
Blinking LEDs indicate a problem. Check the LEDs and the LCD
display and refer to the following solutions:
Media Problems
LED/LCD
Indication
READY and MEDIA LEDs
Blinking
LCD Display
MEDIA OUT
Possible Problems
Solutions
Remarks
Miss-detected gap
Check the media path
Check the position of
the label sensor
For continuous
media, check
application and
driver, and select
continuous media.
Media out
Supply the media roll
Media not installed
Install the media roll
Media jam
Recover the jam
Note: If problem continues perform a label sensor calibration.