Avon Protection 10 DAS775571AA Version 9, December 2015
GR 13313 CR121804
3.6 Getting Started
The packing case contains the following items (see Quick Start Guide):
• Camera with pocket clip fitted
• Charger Station
• Quick Start Guide
• Two rechargeable battery packs
• USB Lead
• Retractable lanyard
• Power Supply Kit:
• Mains power supply
• Set of interchangeable plugs
• Vehicle power lead (12 V)
• Universal Mounting Plate for Charger with 2 mounting screws
• 3 mm hex key (for attaching charger to Universal Mounting Plate)
• 2.5mm hex key (for attaching Picatinny rail – Mi-TIC only)
• 2 mm hex key (for attaching pocket clip and lanyard loop – MI-TIC and Mi-TIC E only)
Basic Operation
• Turn the camera on with a short press of the green button.
• After about one second a start-up image will appear on the screen. (This image may
be changed – see section 5.1). After a few more seconds the display will show the
thermal image.
• The time and date will be displayed for a further 5 seconds.
• Always check the battery indication to verify adequate power and check that a good
thermal image is displayed before commencing operational use.
• While the camera is in operation, it will recalibrate to maintain its performance and
image quality. During recalibration, an internal shutter closes and the image will
briefly freeze while the internal electronics optimises the performance of the sensor.
This occurs more frequently when first turned on, then the calibration interval
increases as the internal temperature of the camera stabilises.
• To turn the camera off, press and hold the green button for two seconds until the
camera turns off.
To Next Page
Loading...
Need help?
General
