Argus Mi-TICS User Manual

 Avon Protection 28 DAS775571AA Version 9, December 2015
GR 13313 CR121804
4 BATTERIES AND CHARGING
The Argus
®
Mi-TIC camera is supplied with two Argus
®
Mi-TIC Lithium Iron Phosphate
Rechargeable Battery Packs (ARG_MI_BLPYN or ARG_MI_BLPSN). These battery type power
the camera for over 2 hours from a full charge regardless of operating mode (e.g. video
recording) and camera type. Batteries must be fully charged before first use.
The optional high capacity battery (ARG_MI_BLPL) gives over 5 hours use from a single charge.
Typical battery run times from a full charge are as follows:
Battery Type
Camera
Type
ARG_MI_BLPYN
ARG_MI_BLPSN
ARG_MI_BLPXN
ARG_MI_BLPL
Optional non NFPA approved
ARG_MI_BAA
Optional non NFPA approved
MI-32X-X-S 2h10 5h10 4h20
MI-32X-X-E
MI-32X-X-NFPA
2h30 6h00 5h00
Run times of a partially charged battery will be proportionally less. Always ensure adequate
power before commencing operational use.
Use at very low temperatures will also reduce battery run time.
4.1 Indications on Charger
No power applied or no battery fitted
Charging
Battery fully charged.
Battery too warm/cold for charging or other fault

Argus Mi-TICS Specifications

General

Brand	Argus
Model	Mi-TICS
Category	Thermal cameras
Language	English