Avon Protection 31 DAS775571AA Version 9, December 2015
GR 13313 CR121804
4. Hook the charger station on to the universal mounting plate.
5. Fasten the charger station to the universal mounting plate with the M4 x 30
mounting screws using the 3 mm hex key as shown.
6. Replace the front panel on the charger station.
4.3.2 Vertical Mounting
Follow the same procedure as for a horizontal mounting, but on a vertical surface.
4.3.3 “Daisychaining” Electrical Installation
Connections should be made via the green power connectors located underneath the
removable front cover. The “daisy chain” power circuit contains a replaceable 10A fuse. This is
also located underneath the removable front cover.
1. Remove the front panels of the charger stations to be connected.
To Next Page
Loading...
Need help?
General
