ARIBEX Nomad Pro Veterinary - Cleaning; Security, Storage, and Transportation

NOMAD Pro
6
Do not operate NOMAD Pro, the handset, charging cradle, or AC power supply if
equipment was subjected to moisture (wetting, immersing, or soaking) –
return to Aribex
for service.
• Do not open the housings. Doing so will void the warranty. There are no user
serviceable parts inside the NOMAD Pro, handset, charging cradle or AC power
supply.
• NOMAD Pro should not be used in environments where flammable cleaning agents
are present.
• Locate the charging cradle away from the normal patient environment.
2.3 Cleaning
n Routinely use a non-acetone based disinfectant wipe (according to chemical manufacturer’s
recommendations) to disinfect the exterior surfaces of the NOMAD Pro and the handset in between use
on each patient.
o Leave the handset connected to the NOMAD Pro and wipe down all surfaces of the device.
p Unplug the charging cradle before cleaning.
NOTE: NOMAD Pro, the handsets, the charging cradle, and the AC power supply are not designed to
be subjected to any kind of sterilization procedure.
Do not spray disinfectant or cleaners directly on the NOMAD Pro, handsets, charging
cradle or AC power supply. The connecting areas are open to ingress and damage to
your device may result.
2.4 Security, Storage, and Transportation
¾
Do not store the NOMAD Pro, handsets, charging cradle, or AC power supply in extreme
conditions: below –20°C (–4°F) or above +60°C (+140°F), or beyond 95% relative humidity (non-
condensing). The optimal storage location is cool, dry, and away from direct sunlight.
¾ Aribex recommends that the NOMAD Pro (like all electronic equipment) be allowed to acclimate
before use when switching between temperature extremes (i.e, cold storage to a warm area use or
hot area storage to a cool area use).
¾ When finished for the day with NOMAD Pro, detach the handset.