ARIBEX Nomad Pro Veterinary - 6 NOMAD Pro Care and Upkeep; Alarms and Alerts

OPERATOR MANUAL..
19
6.0 NOMAD Pro Care and Upkeep
6.1 Alarms and Alerts
The visual/audible alarm signals a programmed action designed to prevent harm to operator, patients,
and/or NOMAD Pro. The visual/audible alerts confirm normal conditions or draw the operator’s attention
to a required action.
NOTE: All audible signals except X-ray termination may be turned down or off in the AUDIBLE SOUNDS
menu – see Section 4.9, Settings Menu.
Condition
Visual
Indicator
Audible
Signal ;Ò
Function /
Resolution
Enabling
Alert
ENABLIN
G X-
RAYS
None
This state is initiated by a single pull and release
of the trigger, within 1 second. If no further
action is taken, the device will shift into the
READY state. If the trigger is pulled again before
the READY state is indicated, the 1 second
counter will restart.
Ready for
exposure
Alert
READY
0.20sec……...
......
Double
ascending
tone
At the conclusion of the ENABLING X-RAYS
message, the READY message will display on-
screen. The READY state will last for 15 seconds,
or until one of the buttons on the user interface
panel is pressed, or until the exposure is
initiated by a second pull of the trigger.
X-ray
Exposure
Alert
X-RAYS
ON
0.20sec…
….........
Single tone,
for duration of
exposure
At the end of the successful exposure the yellow
LED turns off, and display panel briefly indicates
X-RAY COMPLETE and the screen returns to the
normal mode.