p Complete the product Warranty / Registration card and mail it with proper postage to Aribex today.
Completing the card fulfills a condition of warranty coverage (see the inside back cover of this manual).
1.3 Charging the Handsets
NOTE:
The handsets (batteries) are partially charged at the factory and normally need not be charged
up prior to initial use of the NOMAD Pro. However, if the system has been in long-term storage prior to
iniitial use, handsets will first require a proper charge. In fact, it is recommended to fully recharge
handsets every 3 months for long-term storage to ensure that no low battery becomes damaged.
n Use only the supplied AC/DC Power Supply (08500165), unwrap the power cord of the power
supply and connect it to the charging cradle then to an AC electrical outlet (110/120V or 220/240V,
dictated by the country/region). The single green indicator light on the top of the charging cradle will
illuminate when the cradle has power. Position the charging cradle away from the normal patient
environment. A plug adapter may be needed to accommodate the local AC configuration.
o Invert one of the handsets and carefully slide it onto the charging cradle (do not force the handset
onto the charging cradle or damage may result). Expect charge time to be less than 3 hours. The
handset, charging cradle, and AC power supply may become warm to the touch while charging.
p While the batteries are charging, the bank of LED charge indicators will illuminate green in a pulsed
pattern. Once charging is complete, the bank of indicators will illuminate solid green. Remove the
handset from the charging cradle once it is fully charged.
q If the charge indicator lights change to red, it is an indication of problems; consult Section 6.2,
Troubleshooting or an Aribex authorized service center.
To Next Page
Loading...
