Quick Start Guide: CloudVision Appliance 15
Chapter 4
Setting Up CV Applications
4.1 Setting Up CVP
Note Single-Node is not recommended for production deployments.
Pre-installation checklist
• Ensure that you have console access to the CVP virtual machine on each appliance, via
Kimchi web access. See “Web Access into CVX and CVP Consoles via Kimchi” on page 13.
• Enter the CVP Console.
• Ensure all configurations are done via console and not via SSH.
Note This configuration will change the IPs and will drop connectivity if done over SSH.
4.1.1 Setup Steps for Single Node CVP
Step 1 Access primary CVP VM via Kimchi (see “Web Access into CVX and CVP Consoles via
Kimchi” on page 13).
Step 2 Refer to the CloudVision Configuration Guide for Shell-Based Configuration of a Single-Node.
4.1.2 Setup Steps for Multi-node CVP Cluster
Assign to each of the three CVP VMs a role (primary, secondary or tertiary).
• The roles may be assigned in any way, but the roles must be kept consistent throughout the
installation. No two nodes may share the same role.
• Maintain the installation order starting with primary, then secondary and finally tertiary.
Print the CloudVision Worksheet (see Appendix H). Circle the role of each appliance: one primary
(P), one secondary (S), one tertiary (T).
Step 1 Access the primary, secondary and tertiary CVP VMs on the respective appliance via Kimchi
(see “Web Access into CVX and CVP Consoles via Kimchi” on page 13).
Step 2 Refer to the CloudVision Configuration Guide for Shell-Based Configuration of Multi-Node.
To Next Page
Loading...