12
j
WARNING!
Parameter P12 ‘ %FS ‘ is available only for the controller
with 2 SPST relay outputs + 2 semiconductor relay
outputs (variable collector pump speed).
Therefore P12 parameter ‘ MTL ‘ (minimum collector
temperature limitation) will be shown with P13 only
for version with variable collector pump speed, while it
will be shown with P12 for all the other versions.
USIN) T*E ARRO9S ‘ S ‘ or ‘ T ‘ IT IS POSSI$LE TO
CYCLICALLY SCROLL T*ROU)* T*E INSTALLATION
PARAMETERS:
P1: SELECTION INSTALLATION TYPE ‘ SC* ’
P2: SETTIN) T*ERMAL &ATA ‘ &ATA ’
P3: ANTIFROST PARAMETERS MANA)EMENT ‘ O AF ’
P4: ACOUSTIC SI)NAL MANA)EMENT ‘ $EEP ’
P5: LO)IC RELAY SELECTION ‘ ACT ’
P6: INTE)RATION *OURS COUNTER ‘ C A* ’
P7: LOA&S 9IRIN) TEST ‘ TEST ’
P8: CALCULATION OF T*E ENER)Y PRO&UCE& ‘ SEM ‘
P9: RECOOLIN) FUNCTION ‘ REF ‘
P10: PERIO&IC ACTI8ATION OF LOA&S ‘ P8K ‘
P11: MEASUREMENT UNIT ‘ UNIT ‘
P12: SETTIN) OF COLLECTOR PUMP SPEE& ‘ FS ‘
P13:
LIMITATION OF COLLECTOR MINIMUM TEMP. ‘ MTL ‘
PRESS T*E ‘ ‘ KEY TO MO&IFY T*E
SELECTED PARAMETER.
j
PRESS T*E ‘ esc ’ KEY TO RETURN TO T*E INSTALLER
PARAMETERS SELECTION.
j
9AIT 2 SECONDS OR PRESS T*E ‘ esc ’ KEY TO EXIT
T*E INSTALLER MODE.
CONFI)URE DATA FOR E8ERY SIN)LE PARAMETER AS
EXPLAINED $ELO9.
j
To Next Page
Loading...
Need help?
General
