Ariston ELIOS 25 - Parameter P6: Integration Hours Counter; Parameter P7: Loads Wiring Test

31
The counter recording the running hours of the integrative
source can handle values up to . Once the maximum
value is reached the counter stops.
P6: INTEGRATION HOURS COUNTER
Using this parameter it is possible to display the actual number
of hours of the integrative source operation or reset it.
P7: LOADS WIRING TEST
This parameter allows to set the test of the loads wired to
the control unit as well as the wirings themselves.
Depending on the conſgured scheme the power unit will
activate the loads connected by sequentially activating all
the available outlets for 1 seconds each including the alarm
relay and its buzzer.
The number of times for which the entire test is repeated in
multiples of 5 can be set using the single ‘ TMR ’ parameter
present. The activation of the test is signalled on the display
with the ‘ TIMER ’ icon.
j
PRESS T*E ‘  ‘ KEY  T*E DISPLAY
S*O9S ‘*’ FLAS*IN).
PRESSIN) T*E ‘  ‘ KEY RESETS T*E COUNTER
PRESSIN) T*E ‘ esc ’ A)AIN S*O9S T*E CURRENT
RUNNIN) *OURS.
T*E DISPLAY S*O9S ‘*’ AND ACTUAL *OURS OF
ACTI8ITY OF T*E INTE)RATI8E SOURCE.
j
AFTER SELECTIN) PARAMETER P PRESS T*E ‘  ‘
KEY.
j
AFTER SELECTIN) PARAMETER P PRESS
T*E ‘  ‘ KEY.
j
T*E DISPLAY S*O9S ‘ TMR ’ AND T*E NUM$ER OF
CYCLES IN T*E TEST.
j
j
PRESS ‘  ‘. T*E DISPLAY
S*O9S ‘TMR’ FLAS*IN).