Ariston ELIOS 25 - Installation; Assembly with Cable Input on Rear Panel

4
INSTALLATION
TO INSTALL THE DEVICE, PERFORM THE
FOLLOWING OPERATIONS:
¨
1
Remove the central screw and the plastic door.
The installation technician shall operate in full
compliance with all the applicable technical standards
in order to grant the unit safety.
D
WARNING
¨
3
ASSEM$LY 9IT* CA$LE INPUT ON T*E REAR PANEL:
if the cable fasteners (delivered with the unit) are not
reSuired for installation use a screwdriver to remove
the base blocMs permitting the cables to pass through
and ſt the blocMs delivered (see point ).
¨
¨
2
Remove the two screws shown in the drawing then
remove the whole body from the base.