32
Test sequence setting
Data Regulation range Default
TMR 5 .. 25 5
P8: CALCULATION OF THE ENERGY PRODUCED
This parameter permits to manage the data concerning the
measurement of the *eat quantity produced by the plant.
The quantity of energy produced will be stored in the power
unit storage every 2 hours approx.
If the ƀow value being stored is zero the message ‘ FLO9
OFF ‘ will appear on the display and the energy counting will
be deactivated.
Select ‘RESET’ and press ‘ENTER’ to reset the counter of the
energy produced.
If the parameter is not activated in the selected scheme,
the message ‘ NONE ‘ will appear on the display.
PRESS ‘ ‘ TO CONFIRM T*E PRO)RAMMED DATA
AND START T*E TEST. $Y PRESSIN) ‘ esc ’ T*E
MODIFICATIONS ARE CANCELED AND T*E DISPLAY
A)AIN S*O9S T*E NUM$ER OF PRESET CYCLES.
USIN) T*E KEYS ‘ S ‘ or ‘ T ‘ SET T*E NUM$ER OF
CYCLES TO 5 1 15 2 OR 25.
j
AFTER SELECTIN) PARAMETER P PRESS
T*E ‘ ‘ KEY.
j
PRESS ARRO9S ‘ S ‘ or ‘ T ‘ TO CYCLICALLY SCROLL
T*E PARAMETERS FOUR COUNTIN) T*E ENER)Y
PRODUCED:
Plant ƀow rate in litres/minute ‘ FLO9 ‘
Reset of produced energy counters ‘ RST ‘
j
To Next Page
Loading...
