2
WARNING!
It is not possible to set the Maximum Temperature (TM)
to a value higher than the relevant Safety Temperature,
as the Maximum Temperature value is limited to the
value of the Safety Temperature (TS) -5°C. To increase
the Maximum Temperature value, it is ſrst necessary to
increase the value of the Safety Temperature.
Integration Temperature (After Heating) on probe S3
Data Regulation range Default
TA* 4. .. (TM3 -5)uC 45. uC
WARNING!
It is not possible to set the value of the integration
temperature (TAH) at a value which is higher than the
Maximum Temperature (TM3) because the value of the
integration temperature (TAH) is linked to the Maximum
Temperature (TM3) -5°C.
In order to lower the value of the Maximum Temperature
(TM3) below the value of the integration temperature
Hysteresis it is ſrst necessary to increase the value of
the Differential (ţT).
Hysteresis of the safety temperatures
Data Regulation range Default
*YTS 1. .. 15.uC2. uC
Thermostatic hysteresis
Data Regulation range Default
*YT 1. .. 15.uC2. uC
Probe Offset
Data Regulation range Default
OS1 -5. .. +5.uC . uC
OS2 -5. .. +5.uC . uC
OS3 -5. .. +5.uC . uC
OS4 -5. .. +5.uC . uC
Maximum temperature of the probes
Data Regulation range Default
TM2 2. .. .uC . uC
TM3 2. .. .uC . uC
TM4 2. .. .uC . uC
To Next Page
Loading...
