35
Periodic activation of loads
Data Regulation range Default
P8K .. 1 1
Note: ‘ 0 ‘ indicates that the periodic activation of loads is
deactivated, whereas ‘ 1 ‘ indicates it is activated.
P10: PERIODIC ACTIVATION OF LOADS
This parameter permits to manage the periodic activation of
loads (pumps and valves) included in the hydraulic scheme
selected. In particular if a load has not been activated in 21
hours’ time it will be automatically activated by the power
unit for 15 seconds according to the operation logic.
If a load is activated during this time gap the counting will
start again from zero.
The timers counting the waiting and activation time will not
be stored and counting will start again from zero in case of
reset or voltage lack.
The ‘periodic activation of loads’ function will be activated if
the P8K parameter is 1 whereas it will be deactivated if the
parameter is .
AFTER SELECTIN) PARAMETER P1 PRESS
T*E ‘ ‘ KEY.
j
T*E DISPLAY S*O9S ‘ P8K ’.
j
j
PRESS ‘ ‘. T*E DISPLAY
S*O9S ‘P8K’ FLAS*IN).
PRESS ARRO9S ‘ S ‘ and ‘ T ‘ TO SET
T*E DESIRED 8ALUE.
j
PRESS T*E ‘ ‘ KEY TO CONFIRM T*E
PRO)RAMMIN) OR PRESS T*E ‘ esc ’ KEY TO CANCEL
T*E C*AN)ES.
To Next Page
Loading...
