11
3. External termination of condensate drainage pipe via
internal discharge branch (e.g. sink waste - proprietary fitting).
4. External termination of condensate drainage pipe via
condensate siphon
2. External termination of condensate drainage pipe via
internal discharge branch (e.g. sink waste) and condensate
siphon
ii) Connecting into the waste system of the building such
a
s a washing machine or sink trap. The connection
must be upstream of the washing machine/sink (If the
c
onnection is down stream of the waste trap then an
additional trap giving a minimum water seal of 75 mm
and an air break must be incorporated in the pipe run,
as above.
i
ii)Terminating into a gully, below the grid level but above
the water level.
iv)Into a soakway.
NOTE: If any condensate pipe work is to be installed
externally, then it should be kept to a minimum and be
insulated with a waterproof insulation and have a
continuous fall.
Some examples of the type of condensate drains can
be found in this section.
To Next Page
Loading...
Need help?
General