ATS4000 Manager’s Guide 17
3. From either display:
Option Action Result
Acknowledge the
local alarm
Press 0 and
[ENTER]
Acknowledge the local alarm (see
below). Depending on programming a
user code is required to reset.
Display the zone
name in full
Press [NEXT]
Display the complete zone name.
Update the list of
zones
Enter the zone
number and press
[ENTER]
Update the list of zones and display the
next zones in the list (if any).
4. The display shows:
Fix the problem (e.g. close the door).
✍
Re-alarming: If your system has been programmed to remind you about alarms, it
will automatically re-alarm after a preset time unless the cause has been fixed, no
matter how many times you acknowledge the alarm.
When a re-alarm does occur, the letter preceding the zone number will not be
shown.
Resetting a zone in alarm
• The LED of the area in alarm flashes red on the keypad.
• The sirens are active (if programmed),
• When an alarm occurs, the display There Are No Alarms In This Area disappears
from the top line. Instead you see:
✍
Zones in Tamper Alarm are displayed with a T in front of the zone number.
There Are No Alarms In This Area
Code:
Code:
Intelligent Security & Fire Ltd.
To Next Page
Loading...
