ATS4000 Manager’s Guide 27
6. T
EST REPORT
Use this function to display the results of the Disarm Test or Arm Test.
Disarm test report: The test results to see if specific zones and cameras are
operating correctly. The zones need to be programmed to
be included in the test, and operate when areas are
disarmed. All cameras are tested.
The results of the camera tests are only displayed if the
user doing the disarm test has been programmed to test
cameras. Also, Area 1 must be assigned to this user’s
Alarm Group when the user is testing Area 1.
Arm test report: The test results to see if specific zones are operating
correctly. The zones need to be programmed to be
included in the test, and operate when areas are armed.
✍
Where a zone is displayed as untested, it could mean that it has not been tested
because it was missed, or because it was faulty and could not be tested.
To display the results of a test
1. Access menu option 6.
The display shows:
2. Select the test report you want by pressing:
1 [ENTER] for Disarm Test, or
2 [ENTER] for Arm Test, or
[ENTER] to return to the menu.
3. What happens next depends on which option you chose and whether there are
untested zones/cameras:
• Disarm test: (Zone test report is shown first.)
Test Report: 1-Disarm 2- Arm
Option:
Intelligent Security & Fire Ltd.
To Next Page
Loading...
