Aritech Advisor MASTER ATS4000 - 15. TIME AND DATE; To check the time setting press 1; To program a new time and date

44 ATS4000 Manager’s Guide
15. T IME AND DATE
Use this function to program a new time and date.
The time and date are not visible during normal use of the Advisor MASTER system,
however, all internal functions rely on them.
A new date or time only needs to be programmed when the Advisor MASTER system is
first installed, or if the time needs to be adjusted for daylight saving.
The time is programmed for a 24-hour clock.
Access menu option 15
The main menu shows:
To check the time setting press 1
The display shows:
e.g.
1. Press [MENU*] to get an updated time/date
2. Press [ENTER] to return to the main menu
To program a new time and date
1. Enter option 2. The display shows:
(Where hh:mm dd/mm/yy Xxxxday are the current time and date held by the system
as hour, minute, day, month, year and day of the week.)
2. Enter the correct hour (2 digits) and press [ENTER].
The display shows:
3. Enter the correct minutes (2 digits) and press [ENTER].
The display shows:
Time & Date hh:mm:ss dd/mm/yy
X
xxda
y
Hours:
Time & Date hh:mm:ss dd/mm/yy
X
xxda
y
Minutes:
Time 1-Display, 2-Set, 3-DST, 4-Adjust
0-Exit, Menu:
Time 16:41:22 09/03/2000 Thursday
* Update, Enter
Intelligent Security & Fire Ltd.