Aritech Advisor MASTER ATS4000 - 13. START AUTO DISARM TEST; To start the disarm test

36 ATS4000 Manager’s Guide
13. S TART AUTO DISARM TEST
Use this function to start the disarm test.
To start the disarm test
1. Access menu option 13.
The display shows:
2. Press:
[NEXT] to display the untested zones, or
0 and [ENTER] to cancel the arm test and move on to test completed/not completed
display.
3. If you have pressed [NEXT], the untested zones are displayed either one at a time or
as a list:
Zones displayed one at a time Zones displayed as a list
For example: For example:
4. For either display, you can now:
Option Action
Display the description of the selected zone (when
displayed as a list of numbers only)
Enter the zone
number and press
[ENTER]
Display the remaining untested zones (if any)
Press [NEXT]
Move on to the Camera Test or Test Completed/Not
Completed display.
Press [ENTER]
5. The display might shows information about cameras:
Press [ENTER] to return to the original option display.
Note that only cameras allocated to Area 1 are tested.
6. The testing automatically stops when:
• When all zones that are programmed to be tested during disarm test have been
tested, or
• The time allowed for the disarm test has expired.
The display then indicates if the test is completed or not.
Disarm Test, NEXT For Untested
"0"-Cancel:
:
Untested Disarm On 4. PIR In Office
NEXT or ENTER
Untested On 1, 2, 4.
Zone No:
All Cameras Have Tested Successfull
y
Press ENTER
Intelligent Security & Fire Ltd.