14
In case you have an ARJO Shower
panel, use it according to separate ins-
truction.
1 Wheel the Concerto/Basic to the
ARJO combination panel or to a
combination of resident shower and
a sink.
2 Make sure that the drainage hole
comes over the sink.
3 Brake the wheels and lower/raise the
Concerto/Basic to a comfortable
working height.
4 The resident shower is on the right
hand side of the panel.
5 Lift off the shower handle and hold
it over the Concerto/Basic.
6 Set the thermostat mixer at the desi-
red temperature.
7 Turn on the shower water by turning
the valve.
8 Check the temperature and the flow
of water from the shower handle.
9 Adjust the temperature with the
thermostat mixer and the flow of
water with the valve.
10 After the shower, turn off the water
with the valve and dry the resident.
11 Release the brakes and wheel the
resident back.
Shower
6
9
WARNING!
Point the flow of water away from
the resident!
Always check the water tempera-
ture with your hand first!
11
Reference Copy
Published
Check occasionally
for new editions.
To Next Page
Loading...
