ARKEL Elektrik Elektronik Ltd. Şti. www.arkel.com.tr
08.2012
ADrive
49
1.1. STARTUP SCREEN
ADrive 7.5kW
SW:6.5 SN:63012
STARTUP SCREEN
After switching on, the startup screen is displayed. The information of
ADrive power rating, software version (SW) and serial number (SN) are
displayed on this screen.
After being displayed this screen for about 2 seconds, “MAIN
SCREEN” is displayed.
16.2. MONITORING SCREENS
and keys are used for changing the monitoring screens.
READY
RPM: 0 I: 0.0A
MAIN SCREEN (CLOSED LOOP)
Motor rpm (RPM) and motor current (I) are displayed on this screen.
READY
Vout: 0 I: 0.0A
MAIN SCREEN (OPEN LOOP)
Motor output voltage (Vout) and motor current (I) are displayed on
this screen.
MOT.TEMPERATURE
%0
MOTOR TEMPERATURE SCREEN
Approximate motor temperature is displayed on this screen.
RPM : 0
*
RPM ERROR SCREEN (CLOSED LOOP)
Rpm error is displayed on this screen. This error is the difference
between the inverter operation value and the encoder value. ‘*’ sign
indicates this difference by moving left-right. If ‘*’ sign is at the
right side of display, it means motor is running faster than inverter
operates. If ‘*’ sign is on the right side of display, motor is running
slower than inverter’s target speed.
Estimated rpm :
0 Rev./Minute
ESTIMATED RPM SCREEN (OPEN LOOP)
Approximate motor estimated rpm is displayed on this screen.
VBUS:50 F:0.0
Slip: 0.0 Hz
DC BUS / OUTPUT FREQUENCY SCREEN
The DC bus voltage (VBUS), the motor output frequency (F) and the
rotor slip frequency (Slip) are displayed on this screen.
CS:002,003,002
IT:0000 YML 11KW
TECHNICAL SUPPORT SCREEN
This screen is only used by technical supporter.
To Next Page
Loading...