4-KEY READ/WRITE
All parameter of ADrive can be saved to data key and read out from key.
4.1-KEY READ
Parameters in the data key are transferred to inverter.
4.2-KEY WRITE
Parameters of the inverter are transferred to data key
5-FAULT HISTORY
ADrive saves last 256 errors in its memory. By this, facility for maintenance and repairing is
provided.
5.1-Watch Fault List
The list of the faults is displayed on the screen. Last error is number 1 and the oldest error is
number 256.
5.2-Clear Fault List
All faults in the memory are erased.
6-CONTROL TYPE
Determines that if the control of the motor will be in OPEN LOOP (without encoder) mode
or in CLOSED LOOP (with encoder).
6.1 – Control Type (CT: OPEN LOOP / CLOSED LOOP)
When synchronous motor is selected in the menu, this parameter can be adjusted only as a
closed loop.
7-LANGUAGE
Selection of the language is made by this parameter.
7.1 – Language (ENGLISH / TURKCE / FRANCAIS)
8-FACTORY DEFAULT
All parameters of the inverter may be changed to factory defaults. For this select YES to
question “Are you sure to set defaults?” and approve with ENTER button.
To Next Page
Loading...