Arlo Go User Manual

43
6. Settings
You can view and change the Arlo Go settings.
View Device Information
¾ To view device information:
1. Tap the Arlo icon
on your mobile device.
You can also enter
arlo.netgear.com in the address bar of a browser.
The Devices page displays.
2. Tap or click Settings.
The Settings page displays.
3. Tap or click My Devices.
A list of cameras displays.
4. Tap or click the camera.
The settings for the camera display.
5. Scroll down to the Version heading and view the firmware version, hardware
version, and the serial number.
Turn the Camera LEDs O and On
The Arlo Go LEDs indicate the status of the camera. They can be useful during set
up and are helpful when troubleshooting. You can turn the LEDs o and on. We
recommend that you wait until your camera is streaming before turning o the
LEDs..
If you turn o your camera’s LEDs, the LEDs remain o until you turn them back
on again. If you remove and replace your Arlo Go’s battery while the camera is not
plugged in, The LEDs light as usual while the camera is powering up, and then they
turn o again as soon as the camera is done powering up.
¾ To turn o the LED status light:
1. Tap the Arlo icon
on your mobile device.
You can also enter
arlo.netgear.com in the address bar of a browser.
DRAFT
4
3
43

Arlo Go Specifications

General

Brand	Arlo
Model	Go
Category	Security System
Language	English