1508685 Rev D CHP Max Element Management Modules CHP-CMM, CMM-1, SMM, and SMM-1 6-1
CHAPTER 6
CHP MAX ELEMENT MANAGEMENT MODULES
CHP-CMM, CMM-1, SMM, AND SMM-1
This chapter describes the CHP Max Craft Management Module (CMM) and System
Management Module (SMM). To obtain the status, control operation, and set the alarm limits
of the application modules in a CHP chassis, the chassis must have either a CMM (P/N
CHP-CMM or CHP-CMM-1) or SMM (P/N CHP-SMM, or CHP-SMM-1) management module
installed. While the CMM is used for local Craft Management of the chassis in which it is
installed, the SMM may be connected with up to nine other CHP chassis, each containing a
CMM module, to manage all chassis via a remote SNMP manager. In this chapter, CHP-CMM
and CHP-CMM-1 will be referred to as CMM; CHP-SMM, and CHP-SMM-1 will be referred to
as SMM except for items that are only specific to the CMM-1, or SMM-1.
Local Monitoring—page 6-2
Auto Config—page 6-2
Equipment Description —page 6-5
Indicators and Connectors —page 6-6
Functional Description—page 6-8
CHP Max Craft Management Software—page 6-9
Installation of CHP Max Craft Management Software—page 6-10
CHP Max System Management Module—page 6-10
Installation/Replacement of the CMM or SMM—page 6-10
Management Modules Configuration—page 6-12
Resetting the Password—page 6-23
Updating the CHP-CMM Microcontroller Firmware—page 6-29
Updating the SMM, SMM-1 Firmware—page 6-34
MIBs—page 6-39
CHP SNMP Management—page 6-40
CHP Trap Information—page 6-43
SNMP Configuration and Operations—page 6-43
CMM/SMM Specifications—page 6-46
To Next Page
Loading...