Rev D CHP Max AC Power Supply 4-1
CHAPTER 4
CHP MAX AC POWER SUPPLY
The following table lists the minimum revision level to enable all features of this module to
work properly. If you are installing a module and have a later revision, all functions are
compatible unless stated otherwise in the release notes. On occasion, a function may be
removed.
This chapter provides physical and functional descriptions of the CHP Max AC Power Supply
module.
Equipment Description —page 4-1
Connectors—page 4-3
Functional Description—page 4-4
Installing/Removing the Power Supply Module—page 4-5
AC Power Supply Specifications—page 4-17
Equipment Description
The CHP Max AC power supply (P/N CHP-PS/AC1) can no longer be purchased; it has been
replaced by the P/N CHP-PS/AC1-Q power supply with identical specification but uses a
dual-speed fan to allow operation at a reduced noise level and P/N CHP-PS/AC1-SW high
wattage power supply. The low noise power supply operates in the low speed mode when
the ambient temperature surrounding the power supply is less than 31°C and operates in
the high speed mode when the ambient temperature is above 31°C. To achieve full noise
reduction, the chassis with eight quieter dual-speed fans (CHP-CHASSIS-19Q) must also be
used. The CHP Max AC power supplies (P/N CHP-PS/AC1-Q and CHP-PS/AC1-SW) are efficient,
switched-mode modules that accepts AC input from 85 to 264V
AC. This hot-swappable
module produces 246 watts (P/N CHP-PS/AC1-Q) or 475 watts (P/N CHP-PS/AC1-SW) to
provide the DC power required to operate one fully-loaded chassis of application modules.
Module P/N Craft Management S/W
Rev
SMM F/W Rev CMM F/W Rev
CHP-PS/AC1 5.0.4 1.1.0.0 3.002
CHP-PS/AC1-Q 5.0.27 1.6.0.0 3.006
CHP-PS/AC1-Q-NP 5.0.27 1.6.0.0 3.006
CHP-PS/AC1-SW N/A 4.0.0.0 4.033
To Next Page
Loading...