1508685 Rev D CHP Max Element Management Modules CHP-CMM, CMM-1, SMM, and SMM-1 6-17
3. Install a terminator (P/N CHP-XCT-TER) in each unused Shelf Interconnect connector
at the beginning and end of the daisy-chain.
➤ To set SMM IP addresses
4. Click Start > Run and select telnet from the drop-down menu. If telnet is not listed
in the drop-down menu, type telnet in the Open: field and press Enter.
5. At the Microsoft Telnet> prompt, type open 192.168.1.1 and press Enter to open
the default SMM IP address. See Figure 6.10.
Figure 6.10
Using Telnet to Open
the Default SMM IP
Address with
Windows XP
6. Type CCOR as the password and press the Enter key.
7. To view a list of available commands, type help and press the
Enter key.
Note The CHP network cabling must be connected before setting the SMM
addresses.
Note To connect with the SMM, your PC network address must be a different
address than the default SMM IP address (192.168.1.1) but on the same subnet
mask. Note the current IP address of your PC and then temporarily set the PC’s IP
address within the range of 192.168.1.2 to 192.168.1.254, if the SMM IP address is
the default address. If the default SMM IP has been changed, ensure that the first
three segments of the PC’s IP address are identical to the new SMM IP address and
the last segment is different than the new SMM IP address.
Note 192.168.1.1 represents the default SMM IP address. If this IP address has
already been changed to another address, use this changed address instead of
192.168.1.1.
To Next Page
Loading...
