4-16 CHP Max™ Headend Optics Platform Chassis, Controllers and Power Supplies Rev D
11. Select the appropriate file from Table 4.5 on page 4-12 and click Open to initiate the
download. Click OK to confirm that you want to start downloading the firmware.
12. If either an SMM-1 or CMM-1 module is installed in the chassis, after the firmware is
downloaded into the required module(s) click the On radio button in the Autoconfig
window to enable the auto-configuration mode.
Note Do not abort downloading the firmware files. If the file download process is
abnormally terminated, you will need to restart the download process. To do this,
close the GUI and start over using the firmware file in Table 4.5 on page 4-12.
Note If you encounter a problem downloading the firmware, ensure that the
CMM-1 or SMM-1 module is fully inserted into the chassis. If the problem still exists,
replace the CMM-1 or SMM-1 with a spare module to verify if the originally installed
CMM-1 or SMM-1 is working properly.
To Next Page
Loading...