8
②
Use a USB cable to connect your Studuino to your PC. Now choose Transfer from the
Run menu to transfer your program.
Click
Click
①
②
Seeing the message below disappear means that your program has been successfully
transferred to your Studuino. The LED will light up automatically once the transfer nishes.
Your program didn’t transfer correctly if you see any of the messages below. Check the solutions
and try again.
Message
Solution
Could not access to Studuino
Make sure Studuino is connected to the
PC.
Make sure your USB cable is properly connected
to your PC and Studuino
Could not access to Studuino
Serial port already in use. Try quitting
any programs that may be using it.
Close any applications that may be
communicating with your Studuino. If no other
applications are communicating with the board,
unplug the USB cable and press the onboard
Reset button.
To Next Page
Loading...
