Artec Studuino - Working with LEDs; Connecting and Configuring LEDs

5
3. LEDs
Learn how to program an LED in this chapter. It covers connecting devices to your Studuino,
setting ports, programming in the Block Programming Environment, and transferring data to
the board.
3.1. Connecting an LED
Connect an LED to Sensor/LED/Buzzer connector A4 on your Studuino.
3.2. Port Settings
Before you start programming, you’ll need to tell the Block Programming Environment which
Studuino ports you’ll be using. Open the Block Programming Environment and choose Port
Settings under Edit in the menu bar to open the Port Settings dialog.
LED
A4
Keep an eye on your cables!
The gray wire should be at the top.
Gray
Black
Black
Click
Click
①
②
You’ll see the
Port Settings dialog