Artec Studuino - Getting Started with Studuino; Introduction to Studuino Guide; Setup and Installation Guide; Installing Studuino Software

1
1. Getting Started
This manual explains how to use the following electronic parts in the Block Programming
Environment:
LEDs
Buzzers
Push-buttons
Light Sensors
IR Photoreectors
Touch Sensors
Sound Sensors
The information in this manual may be revised at any time.
2. Setup
2.1. Installing Studuino Software
Follow the steps below to download the instruction manuals
you’ll need to install your Studuino software.
1) Go to the Studuino website at http://www.artec-kk.co.jp/studuino/en/
2) Mouse over Software and click Studuino or Studuino mini.
3) If you’ve chosen Studuino, use the next page to choose your system.
4) On the next page, go to the Software section and click the button for your operating system
to download the software.