Artec Studuino - Page 19

15
③
Connect the
block to the block. Now set the value in the
block to 0.5.
④
Connect the
block to the block.
Now you’ve programmed your LED to blink ten times in 0.5-second intervals.
③ Wait for time (0.5 seconds)
⑤ Wait time (0.5 seconds)
②
Click here and type
①
Drag
and Drop
Drag
and Drop
Use a USB cable to connect your Studuino to your PC. Now choose Transfer from the Run menu to
transfer your program. The LED will blink 10 times in 0.5-second intervals once the transfer nishes.
①
Set time to 0.5
② Turn on
LED
LED
④ Turn off LED
Repeat 10 times