3) Cutting
• Use the Pipe Cutter or Circular Saw for cutting the workpiece. Do not gather cut workpieces
into the tank and take them out.
3-1）Pipe Cutter
(1) Swing the Pipe Cutter upward to out-of-way position, turn the Rack Handle to move the Pipe
Cutter to the position for cutting the workpiece. (fig8)
(2) Move the Pipe Cutter down on to the work piece, then turn the Switch ON.
(3) Turn the handle clockwise with a force and start cutting the workpiece. (fig.9)
(4) Swing the Pipe Cutter upward to out-of-way position and return.
(5) Do not gather cut pipes in the tank. Remove them from the tank.
• Do not touch the cut surface with hands because it is hot and sharp.
• If the Cutter Handle is turned forcibly, the cut section of piping forms an
oval shape, preventing proper threading. Turn the Cutter Handle a half turn
per one turn of the pipe.
15
Turn Rack handle to
the cutting position．
〈8〉
Rack Handle
Turn handle to start cutting．
Lower
Pipe Cutter
〈9〉
To Next Page
Loading...