3) Daily Inspection and Maintenance
* Immediately replace Power Plug, Power Cord and extension cord, if damage.
* Ensure the oil is filled up to the tank lid wire netting. If not, replenish.
* Adjust with the Oil Adjust Screw if the amount of threading oil discharged from the Die-Head
is not appropriate.
* Contamination in the tank causes pump failure. Clean the tank on a periodic basis.
* Check the Dies, Cutter and Reamer Blade for chipping. Replace if chipped.
* Clogged chuck jaws cause improper chucking. Clean with wire brush.
* Check for loose fitting screws of parts. If used loosened, danger can result. Retighten them.
* Completely wipe off dirt and chips from the machine.
* Coat the machine with rust preventive grease when the machine is not used for a long period
of time.
31
• Do not wet the motor with water or oil.
To Next Page
Loading...