• Always ground the machine to avoid electric shock or resultant death.
• Do not touch the plug with wet hands.
• Do not expose the machine to rain and water and do not use it in damp
or wet locations. Humidity will deteriorate motor insulation or lead to
electric shock.
• Immediately replace Power Plug, Power Cord or extension cord, if
damaged.
• Do not hold the Power Cord and pull it to disconnect from the receptacle
and do not put the machine on the cord and damage it.
• An extension cord used should be a three-core cabtyre cable having
an earth wire. Use a thick and durable cord for outdoor use.
• Toxic chlorine gas is generated. Do not burn the threading oil (Red).
In case anyone should inhale the gas, move the person to a place of
fresh air, and consult a doctor without a delay.
• Be sure to use the threading oil (White) for working water pipes.
• The workpiece, Hammer Chuck and Scroll will rotate during working.
Loose clothing can get easily tangled into moving parts.
2
Electric Shock
Earth
Toxic Gas
Rotating parts
CAUTIONS IN USE
• Always use the machine at the voltage indicated on Machine Plate.
Otherwise, the machine may become hot, emit smoke or catch fire.
• Do not force the machine in a manner that the motor stops due to an
overload such as a worn Dies.
• Do not handle or use the threading oil near a fire.
• Immediately replace the Power Plug, Power Cord and extension cord, if
damaged.
• If the machine has emitted smoke or took fire, do not disassemble it
but have it inspected or repaired by a qualified person.
• Never install an earth wire to the gas pipe. If attempted, explosion may
take place.
• Do not use the machine in the presence of flammable liquids or gases
such as gasoline and thinner. Otherwise, ignition or explosion may
take place. Cutting Blade.
Fire
Ex
losion
To Next Page
Loading...