INSTALLATION AND OPERATION MANUAL
CR3 CR5, and CR7 Charging Racks Charging Rack Installation
Table 4 Wiring color codes
IEC US Old
1
Load Also called
Brown Black Red Active Line, Hot
Blue White Black Neutral Return, Cold,
Grounded
connector
Gr/Ye
2
Green Green Earth Ground, Safety
Earth, Earth
Ground,
Grounding
conductor
3
1. The "Old" standard was used in various countries (including Australia), and some wiring may still use these colors.
2. Gr/Ye - Green with Yellow stripe - this is the standard world wide, although it is not common in the US or Canada at present.
3. There is an important distinction between "Grounding conductor" (safety earth) and "Grounded conductor" (Neutral). These are
US terms for the conductors and they are not interchangeable, despite the similarity of the names
Installation of Additional Units in a Serial Power Configuration
Do not connect more than five units in a power series. Serial power configuration is only allowed
for wall mounted Charging Racks, it is not allowed for Charging Racks used as a single desktop
unit placed on a table.
Do not connect more than four units to one single LAN outlet in a LAN series.
Important
It is not allowed to connect additional Charging Racks or Battery Pack Chargers if the
chargers are connected to the power supply via an AC plug.
Important
Disconnect the power supply connection before working on the units.
1. If the additional Charging Rack has not yet been mounted on the wall, do this according to Figure 4.
Mounting dimensions in mm. Charging Rack seen from the back, page 7.
2. Open the top cover of the Charging Rack closer to the AC power source.
3. Remove the cover which protects the unused AC output terminal block of the charger closer to the AC
power source.
TD 92480EN / 30 October 2020 / Ver. L 10
To Next Page
Loading...
Need help?
General