ASCOM Myco 2 - Back Button; Overview Button; Proximity Sensor; Multifunction, and Alarm Button

TD 93066EN
User Manual
Ascom Myco Smartphone
3. Handset Description
12
14 May 2018 / Ver. K
3.1.4 Back Button
1
• Press to navigate backwards, to the previous screen. This will result in different behavior,
depending on where you are in the user interface.
-Inside a menu, pressing the back button will navigate up one level.
-At the top level of a menu, pressing the back button will exit the menu and go back to
the application main screen.
-On the main screen of an application, pressing the back button will navigate back to the
Alert view or the app from which the current app was launched.
3.1.5 Overview button
2
• Press to show a list of images that represents apps that have recently been used (with the
most recently used app at the top). Pressing any of the images will launch the
corresponding app.
3.1.6 Proximity Sensor
The Proximity sensor automatically puts the screen in sleep mode when you hold the handset
close to your head, to avoid unintentional screen taps. When you move the handset away from
your head, the screen automatically turns back on.
3.1.7 Multifunction, and Alarm Button
The Multifunction/Alarm button located on the top of the handset can be programmed for
different kinds of functionality, such as:
• Place a call
• Act as a walkie talkie button (see 5.7 Push-to-Talk Group Call on page 45)
• For alarm functionality (see 10. Personal Alarm on page 66).
Some third-party apps can also be configured to use the button for input.
Use the button in the following ways:
• Long press
-Press and hold the button.
• Double press
-Press the button twice within two seconds.
The functionality for long press and double press differ depending on the system configuration.
For more information on how to configure the multifunction and alarm button, please refer to
the Configuration Manual, Ascom Myco Smartphone.
3.1.8 Top Display
With the top display, you get information about incoming calls, messages, or alerts, without the
need to look at the front display.
• Refer to 7.2.1 Top Display on page 53 for details on how alerts are shown in the top display.
• Refer to 11.2 Color-Coded LED Signals on page 69 for details on how other notifications are
shown in the top display.
1.Designated hardware button on Ascom Myco 2, software button at the bottom of the screen on earlier models.
2.Designated hardware button on Ascom Myco 2, software button at the bottom of the screen on earlier models.
NOTE: If a third-party app is using the button, no other multifunction or alarm button
functionality can be used.