TD 93066EN
User Manual
Ascom Myco Smartphone
5. Calling
47
14 May 2018 / Ver. K
• The invitation is of higher priority than the priority of the ongoing call.
If the priority of the PTT invitation is lower than the ongoing call, or if the invitation is not
configured to be accepted automatically, the invitation must be accepted in the same way as a
regular PTT invitation (see To Accept a PTT Invitation on page 46). If the invitation is accepted
while the call is still ongoing, the call is automatically disconnected.
5.7.2 Use the PTT Call Screen
The push-to-talk call screen is used when communicating in a PTT group call session.
Figure 35. The push-to-talk call screen.
The following options are available during a PTT session:
• Tap and hold Push-to-talk to open the microphone for transmitting. The microphone is
muted again when the button is released.
TIP: If configured, the Multifunction button on the top of the handset can also be used as a
push-to-talk button.
•Tap Speaker to enable/disable the loudspeaker. Use the Volume up, or Volume down
buttons to adjust the volume.
•Tap End call to disconnect from the PTT session. For instructions on how to rejoin a
disconnected session, see 5.7.4 Rejoin a PTT Call Session on page 48.
• Press the Home button to hide the call screen temporarily, without disconnecting from the
PTT session. Information about the ongoing session is displayed in the phone bar (see 5.4.11
The Phone Bar on page 44 for details about the phone bar). The push-to-talk button on
the phone bar can be used to open the microphone for transmitting, in the same way as on
the call screen.
NOTE: When a PTT invitation has the highest possible priority level (priority 1), the
ongoing call is always disconnected immediately.
NOTE: A PTT session can be terminated remotely by the system. All users are
automatically disconnected from a terminated session.
To Next Page
Loading...
