TD 93066EN
User Manual
Ascom Myco Smartphone
7. Alerts
56
14 May 2018 / Ver. K
7.4.1 Colors
Colors can be used to show the category, or priority of an alert. The color of an alert is shown
by a color bar to the left of each alert in the alert view. For incoming alerts, the color is also
shown on the color-coded LED beacon, refer to 11.2 Color-Coded LED Signals on page 69.
Figure 42. Alerts labeled with colors.
The following colors are available:
•Red
•Green
•Blue
•Yellow
•Orange
•Cyan
•Purple
•Pink
•Dark Red
•Brown
•Grey
•White
•Black
The table below is an example of how colors are used to show priority for patient monitoring
systems:
Priority Color Priority Used for Event Indications (if enabled)
Red High High priority alert Top display notification, red flashing
LED beacon, sound, and vibrator.
IMPORTANT: These indications are
always enabled, and cannot be
turned off
Yellow Medium Medium priority alert Top display notification, yellow
flashing LED beacon, sound, and
vibrator.
Cyan Low Low priority alert Top display notification, fixed cyan
LED beacon, sound, and vibrator.
NOTE: The use of colors is dependant on configuration, and can differ between
system setups.
To Next Page
Loading...
