TD 93066EN
User Manual
Ascom Myco Smartphone
19. Troubleshooting
90
14 May 2018 / Ver. K
19.2 Warning Messages
The signal strength
indicator fluctuates a
lot, or shows a lower
value compared to
other devices such as
commercial
smartphones.
The signal strength indicator on
the handset is configured to be
more sensitive compared to
commercial smartphones, to
prevent interruptions to the
mission critical communication.
Do not compare the signal
strength indication on the
handset to other non-mission
critical devices such as
commercial smartphones.
Message Details
Shown when automatically logged out from the
handset. This most commonly happens when the
same user logs in on a different handset, using a
shared phone.
The Wi-Fi or DECT connection has been lost. No
alerts, messages, Wi-Fi, or DECT calls. Try to
move to another part of the room/building, or
move inside a network connected building if you
are outside.
Connection to the Unite CM/Unite CS has been
lost. No alerts or messages can be received. Wait
until the connection is restored.
The PBX connection has been lost. Wi-Fi or DECT
calls are unavailable. Wait until the connection is
restored.
NOTE: This warning is not shown on cellular
handsets with an active cellular connection.
Fault Probable Cause Action/Comment
To Next Page
Loading...
