INSTALLATION GUIDE
Room Controller 4 (NIRC4-xMN)
Installation
3 Installation
The NIRC4-xMN has an IP40 ingress protection. The areas in which NIRC4-xMNs are to be installed must be
clean, dry, and weatherproof. The walls on which devices are to be installed should be finished (painted,
wall papered, etc.) before the devices are installed. It is important to have the appropriate length of free
cable available at every location where the NIRC4-xMN is to be installed. The length of stripped cable and
the length of exposed copper wire shall conform to the installation instructions for each module that is to be
connected.
TD 93351EN / 21 March 2022 / Ver. B 3
To Next Page
Loading...
