ASCOM NIRC4-xMN - Mounting NI-series Connectors

Terminating and Mounting Room Bus Connectors for NI-
series Modules
INSTALLATION GUIDE
Room Controller 4 (NIRC4-xMN)
10.1 To mount the active room bus connectors:
1. Ensure the active room bus cables are properly terminated with an 8-pin block connector.
2. Orient the block connector NICT-8AA such that the wires face down.
-or-
Orient the block connector NICT-8CA such that locking clips face down.
3. Seat the block connector on an active room bus terminal.
4. Repeat steps 2 and 3 for each remaining active room bus terminal, as shown in the following figures.
Figure 15. Room bus connections NICT-8AA (NI-series modules)
Figure 16. Room bus connections NICT-8CA (NI-series modules)
16 TD 93351EN / 21 March 2022 / Ver. B