56
2. Frequency: Select the frequency band to configure professional settings.
3. WiFi Network Name: A name whose length is less than 32 characters is used to
identify a wireless network.
4. TX STBC: Enables or disables the Space Time Coding Block (STBC) feature, as
described in 802.11 specification, in transmitting (TX) direction.
5. RX STBC: Enables or disables the Space Time Coding Block (STBC) feature, as
described in 802.11 specification, in receiving (RX) direction.
6. Set AP Isolated: Prevent wireless devices from communicating with each other via
WiFi Router. This feature is useful if many guests frequently join or leave your
network. Select [Yes] to enable this feature or select [No] to disable.
7. Multicast Rate (Mbps): Setting transmission rate for multicast.
8. Short Guard Interval: Defines the length of time that the WiFi Router spends for
CRC (Cyclic Redundancy Check). CRC is a method of detecting errors during data
transmission. Select Enable for a busy wireless network with high network traffic.
9. DTIM Interval: DTIM (Delivery Traffic Indication Message) Interval or Data Beacon
Rate is the time interval before a signal is sent to a wireless device in sleep mode
indicating that a data packet is awaiting delivery. The default value is three
milliseconds.
10. Current DTIM Interval：
：：
：The article represent a current state.
11. WMM: Enables or disables WMM capabilities in the driver. The WMM capabilities
perform special processing for multimedia stream data including voice and video
data.
To Next Page
Loading...
Need help?
General
