Askey SAX1V1K User Manual

59
1. From the navigation panel, go to Advanced > Network > IPv6.
2. Connection Type: Select IPv6 connection type to configure Disable, Native and
Static IPv6.
3. WAN IPv6 Address: Set the WAN interface’s ipv6 address.
4. WAN Prefix Length: Set the WAN interface’s ipv6 prefix length.
5. WAN IPv6 Gateway: Set the WAN interface’s ipv6 gateway.
6. WAN IPv6 MTU: Set the WAN interface’s IPv6 MTU (Maximum Transmission Unit).
7. User Class Option: The user class option (15) of ORO that DHCPv6 clients send to
the DHCPv6 server by solicit message.
8. Auto Configuration: The WAN interface’s address assign type (SLAAC). Enable:
WAN interface can get ipv6 address by SLAAC. Disable: WAN interface gets the ipv6
address only by Stateful.
9. Enable LAN: Enable/Disable WiFi Router allocating IPv6 addresses for LAN-side
devices.
10. LAN IPv6 Address: Set LAN interface’s IPv6 address.
11. Simultaneous: The mode which hosts connected to the LAN interface can get IPv6
addresses. When enabled, hosts get IPv6 address by simultaneous Stateless and
Stateful (requires address between DHCP pool start and end values). When
disabled, hosts do not get IPv6 addresses simultaneously, and a mode must be
selected instead (SLAAC + RDNSS, SLAAC + Stateless DHCPv6, Stateful DHCPv6).
12. LAN Prefix Length: Set LAN interface’s IPv6 prefix length.
13.
LAN IPv6 Prefix: Set LAN interface’s prefix.

Askey SAX1V1K Specifications

General

Brand	Askey
Model	SAX1V1K
Category	Wireless Router
Language	English