This setting allows the induction hob to automatically activate the
suction of the extraction module every time the induction hob is turned
on. Depending on the value you set, the suction will automatically
start at that speed level when any cooking zone is activated.
hSt - Synchro Start
(Synchro Start Level
With this setting, when the appliance is switched off, the extraction
module can also be switched off automatically and the Air-Dry function
can be activated if necessary. If there are still hot pans on the hob,
the Air-Dry function will start at a higher setting if essential until all
cooking zones have cooled down. Then Air-Dry continues with the
normal cycle of 10 minutes on extraction level 1.
hSp - Synchro Stop
Synchro Stop, switch off
function extraction module
This setting allows the induction hob to control the extraction module.
The extraction module will automatically switch on when setting a
cooking zone power. The cooking zone with the highest power setting
determines the degree of extraction. Synchro Control can be overruled
by using the + (plus) and - (minus) keys and it can be reactivated by
touching the + (plus) and - (minus) keys simultaneously. The response
sensitivity can be set: L3 (high), L2 (medium), L1 (low), off.
hSC - Synchro Control
Synchro Control response
Level
To unpair, all the Bluetooth devices set this setting to Clr. All your
connected Bluetooth devices are now unpaired.
btC - Bluetooth clear
Bluetooth clear paired
devices
To pair a Bluetooth device, set this setting to on. You now have 3
minutes to pair a new Bluetooth device to this induction hob.
btP - Bluetooth pairing
Bluetooth device pairing
Activate this setting if a recirculation filter is installed. There are 3
options available:
rCi - Recirculation filter
Recirculation filter
off - (default)
CAr - Recirculation filter
PLA - Plasma
Activate this setting if the filter cleaning indication is desired. There
are 4 options available:
grF - Clean grease filters
indicator
Clean grease filters indicator
off - Manually
L1 - Cooking and frying small quantities
L2 - Cooking and grilling medium quantities (standard)
L3 - Frying, grilling, and woking
To receive firmware updates for the cooking hob, you need to be
paired to the cooking hob via the mobile app. You will receive a
notification, or you can check available firmware updates on the
mobile app menu for updates.
FoA - Firmware update over
the air
Firmware update via Wi-Fi
In order to start the firmware update via the mobile app, set this setting
to on to confirm your presence at the cooking hob. For more
information, see chapter "Wi-Fi Connection setup". After 10 min, this
setting is automatically reset to off.
Table continued from last page
48
Settings
To Next Page
Loading...
