If your electrical wiring or circuit breakers do not meet the specified
current draw on the rating plate, the current limiter can be activated
by reducing the value of this setting. Doing so may cause a reduced
performance of the induction hob.
Con - Connection power
Current limiter
(connection to power grid)
The following numbering format of the setting is available: X.XX.
The number left of the dot represents the number of connected
phases, while the number right of the dot represents the electrical
current per phase in Ampere.
NOTE!
To prevent unintentional adjustment of the 'CON - connected
power', CON setting must be confirmed when changed by
touching the slider for 3 seconds. A change without confirmation
will not be implemented!
WARNING!
The appliance must always be set to the actual or lower rating of
the electrical wiring or circuit breakers. This setting can only be
set by an authorised expert.
In demo mode, the appliance will act as usual, without the possibility
to heat the cookware.
dE - Demo mode
Demo Mode for Dealer
Showrooms When set, this will be indicated after switching on the appliance with
a short "d" indication.
Without any user interaction, the appliance will automatically switch
off after 10 minutes.
Disable this setting if it is undesirable for the tower to rise automatically
when the extraction is switched on.
Ato - Automatic raising of the
tower
Automatic raising of the
tower
Display current firmware version.Fir - Firmware version
Firmware version
Resets to default settings.rES - Factory reset
Factory reset
Table continued from last page
49
Settings
To Next Page
Loading...
